Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Thermoplastics piping systems for fluids under pressure — Flange adapters and loose backing flanges — Mating dimensions
It applies to flange adapters and loose backing flanges for use with pipes with nominal outside diameters (dn) from 16 mm to 2 500 mm and nominal pressures up to 25 bar[1] (PN 25).
This document specifies the dimensions of the flange adapters intended to be used for:
— butt fusion piping systems;
— socket fusion piping systems;
— adhesive jointed piping systems.
NOTE 1 For specific connections with dimensions (e.g. dn450 or dn630) not covered in this document, or specific equipment (butterfly valves), specific solutions are available on the market.
This document is applicable to loose backing flanges made from metal, thermoplastics, or a combination of metal and thermoplastics.
This document also provides information on gaskets and gives general recommendations on correct assembling practices.
NOTE 2 Industrial applications are not covered by this document. Products intended for industrial application are covered by ISO 15493[1], ISO 15494 or ISO 10931[2].
[1] 1 bar = 0,1 MPa = 105 N/m2.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
