CSA ISO/IEC 18745-1:25

CSA Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the SCC Mirror Committee (SMC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. For brevity, this Standard will be referred to as "CSA ISO/IEC 18745-1" throughout. The International Standard was reviewed by the CSA TCIT under the jurisdiction of the CSA Strategic Steering Committee on Information and Communications Technology and deemed acceptable for use in Canada. This Standard has been formally approved, without modification, by the Technical Committee and has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope This document provides a set of instructions for evaluation of MRPs which may incorporate contactless integrated circuits. This evaluation is an instrument to establish the ability in principle of a specific type of document to fulfil the requirements of use. It supplies a structured approach to evaluate MRPs by: — defining reproducible stress methods to submit the document(s) under evaluation to specific stress or environmental conditions; — defining reproducible evaluation methods to measure numerical values for specific document properties; — defining test sequences that specify the order in which stress methods and evaluation methods are to be performed; — defining test plans to link specific user requirements to test sequences and related parameters. It specifies the minimum criteria to be achieved in order to meet ICAO’s expectations for durability of fully personalized MRPs.