Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation
1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.
1.2 The procedures appear in the following sections:
Procedure | Section |
Arc resistance | 23 |
Ash | 6 |
Bond strength (ply adhesion) | 16 |
Bursting strength | 14 |
Compressive strength | 12, 25, 30 |
Conditioning | 4 |
Density | 17, 26, 32 |
Dielectric strength | 18, 27 |
Dimensional measurements | 28, 33 |
Flammability | 22 |
Flexural strength | 13, 31 |
Silica | 7 |
Tearing strength | 11 |
Tensile strength | 10, 24, 29 |
Thickness (sheets) | 20 |
Resistance to impact | 15 |
Rockwell hardness | 19 |
Volatile matter | 8 |
Water absorption | 5 |
Zinc chloride | 9 |
1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 7.3, 22.1, 22.2.
Note 1: The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures. Conduct comparative tests if necessary before directly comparing results of tests using the different procedures.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
