logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM C285 : 24

Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel

Standard Details

1.1 These test methods cover the determination of the fineness of frit in wet- or dry-milled porcelain enamels and other ceramic coatings for metals by means of the No. 200 (75-μm) or No. 325 (45-μm) sieve.

1.2 The two methods appear as follows:

Sections

   Method A—Referee Method
   Method B—Routine Method

 4 to 9 
10 to 14

1.3 Method A is intended for use where a referee method of higher accuracy is required, while Method B is intended to meet the needs of normal enamel plant production control operations where a rapid, simplified method of sieve testing is required. The accuracy of the simplified method has proved to be entirely adequate for this use. The simplified test, however, is not recommended where high accuracy is required.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE
Standard Type: Main
Document No: ASTM C285 : 24
Document Year: 2024
Pages: 3
  • Section Volume:
  • 02.05 Volume 02.05 Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products

Life Cycle

Currently Viewing

ACTIVE
ASTM C285 : 24

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +