logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM D3677 : 10e1

Standard Test Methods for RubberIdentification by Infrared Spectrophotometry

Standard Details

1.1 These test methods cover rubber identification and are based on infrared examination of pyrolysis products (pyrolyzates) and films.

1.2 These test methods are applicable to rubbers in the raw state and, when compounded, both in the cured and uncured state.

1.3 Since it is customary in infrared spectrophotometry to use wavenumbers (cm1) rather than Hertz (Hz), the unit for frequency in the SI system, the former is employed throughout this test method.

1.4 This test method assumes that specimens and infrared spectra are prepared and analyzed by experienced personnel and that the equipment is operated according to the manufacturer's direction for optimum performance. No details for operation of infrared spectrophotometers are included in this test method.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 17.

General Information

Status : Historical
Standard Type: Main
Document No: ASTM D3677 : 10e1
Document Year: 2010
Pages: 21
Edition: e1
  • Section Volume:
  • 09.01 Volume 09.01 Rubber, Natural and Synthetic -- General Test Methods; Carbon Black

Life Cycle

Historical

Currently Viewing

Historical
ASTM D3677 : 10e1

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +