ASTM D5947 : 11

Standard Test Methods for Physical Dimensions of Solid Plastics Specimens

Standard Details

1.1 These test methods cover determination of the physical dimensions of solid plastic specimens where the dimensions are used directly in determining the results of tests for various properties. Use these test methods except as otherwise required in material specifications.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This standard and ISO 16012 address the same subject matter, but differ in technical content.

General Information

Status : Historical

Standard Type: Main

Document No: ASTM D5947 : 11

Document Year: 2011

Pages: 10

Section Volume:
08.03 Volume 08.03 Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products