ASTM D4325 : 20

Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

Standard Details

1.1 These test methods cover the methods and procedures for testing electrically insulating and semi-conducting rubber tapes designed for splicing, terminating, and sheath repair of electrical wire and cable.

1.2 The test methods appear in the following sections:

	Section
Referenced Documents	2
Conditioning	5 – 6
Dielectric Strength	35 – 40
Dimensions	11 – 16
Dissipation Factor	22 – 26
Elongation	17 – 21
Heat Exposure	46 – 49
Fusion	7 – 10
Ozone Resistance	41 – 45
Permittivity	22 – 26
Sample Requirements	4
Tensile Strength	17 – 21
Volume Resistivity	27 – 34
Ultraviolet and Weather Resistance	50 – 54

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

Note 1: There is no IEC equivalent to these methods.

1.4 Unless otherwise stated, measurements are made on tapes from which the removable separator has been removed.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statement see 43.1.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.