Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Standard Test Methods for Evaluating Design and Performance Characteristics of Stationary Upright and Recumbent Exercise Bicycles and Upper Body Ergometers
1.1 These test methods specify procedures and equipment used for testing and evaluating stationary exercise bicycles and crank training equipment (machines) for compliance to Specification F1250. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In case of a conflict between this document and Specification F1250, Specification F1250 takes precedence.
1.2 Requirements—Stationary exercise bicycles and crank training equipment are to be tested for the parameters specified in Specification F2276 and Test Methods F2571 and the following parameters unique to this equipment:
1.2.1 Seat post construction and loading
1.2.2 Handlebar construction and loading
1.2.3 Pedal construction and loading
1.2.4 Crank Arm and Enclosure Entrapment
1.2.5 Seat back support loading
1.2.6 Stability
1.2.7 Direct Drive Exercise Bicycle Pedal Endurance
1.2.8 Warnings
1.2.9 Documentation
1.3 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
