logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM E930 : 18

Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)

Standard Details

1.1 These test methods describe simple manual procedures for measuring the size of the largest grain cross-section observed on a metallographically prepared plane section.

1.2 These test methods shall only be valid for microstructures containing outlier coarse grains, where their population is too sparse for grain size determination by Test Methods E112.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE
Standard Type: Main
Document No: ASTM E930 : 18
Document Year: 2018
Pages: 6
  • Section Volume:
  • 03.01 Volume 03.01 Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography
  • ICS:
  • 19.120 Particle size analysis. Sieving

Life Cycle

Currently Viewing

ACTIVE
ASTM E930 : 18

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +