ASTM D2148 : 18

Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation

Standard Details

1.1 These test methods cover tests for bondable silicone rubber tapes which form a sealed structure either with the application of heat (and pressure if needed) or by the process of auto-adhesion (self-fusing).

1.2 The methods appear in the following sections:

Test Method	Section

Adhesion	3 – 10
Bond Strength	11 – 18
Dielectric Breakdown Voltage	19 – 26
Hardness	41
Length	33 and 34
Thickness	27 – 32
Width	36 – 40

1.3 The values stated in inch-pound units are to be regarded as standard, except for °C. The values in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement see 23.1.1.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.