Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Standard Test Method for Wet Filterability of Lubricants and Hydraulic Fluids by Mass Flow Technique
1.1 This test method covers determination of the wet filterability of lubricants and hydraulic fluids based upon mass flow rate measurements through a 0.8 µm membrane after ageing of the fluid in the presence of water. The procedure applies to lubricants and hydraulic fluids that are formulated with American Petroleum Institute (API) Group I, II, III, IV and certain V base stocks. Products formulated with water or base stocks that are heavier than water are out of scope.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
