ASTM D5930 : 09

Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique

Standard Details

1.1 This test method covers the determination of the thermal conductivity of plastics over a temperature range from – 40 to 400°C. The thermal conductivity of materials in the range from 0.08 to 2.0 W/m.K can be measured covering thermoplastics, thermosets, and rubbers, filled and reinforced.

1.2 The values stated in SI units shall be regarded as standard.

1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish proper safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this test method.

General Information

Status : Historical

Standard Type: Main

Document No: ASTM D5930 : 09

Document Year: 2009

Pages: 5

Section Volume:
08.03 Volume 08.03 Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products