logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM F373 : 13(2022)

Standard Test Method for Embossed Depth of Resilient Floor Coverings

Standard Details

1.1 Two important characteristics involved in the manufacture of resilient flooring relate to the smoothness of the wear surface and the hardness of the layers under the wear surface. The surfaces may vary from completely textured areas to portions that are flat but separated by textured areas. This test method covers flooring with these interrupted wear surfaces which are not supported by soft, cushioned layers.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE
Standard Type: Main
Document No: ASTM F373 : 13(2022)
Document Year: 2013
Pages: 2
  • Section Volume:
  • 15.04 Volume 15.04 Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings
  • ICS:
  • 97.150 Non-textile floor coverings

Life Cycle

Currently Viewing

ACTIVE
ASTM F373 : 13(2022)

Historical

Historical

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +