ASTM D5946 : 17

Standard Test Method for Corona-Treated Polymer Films Using Water Contact Angle Measurements

Standard Details

1.1 This test method covers measurement of the contact angle of water droplets on corona-treated polymer film surfaces.

Note 1: This standard is identical to ISO 15989.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE

Standard Type: Main

Document No: ASTM D5946 : 17

Document Year: 2017

Pages: 7

Section Volume:
08.03 Volume 08.03 Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products