logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM F3733/F3733M : 24

Standard Test Method for Assessing Carpet Wetness after Cleaning with a Wet Extraction Cleaning System

Standard Details

1.1 This test method provides only a laboratory test for determining the relative carpet wetness after cleaning with a wet extraction cleaning system when tested under standard conditions.

1.2 This test method assesses the wetness of carpets by measuring the weight (mass) of remaining moisture in carpet after performing a standard cleaning cycle, and then calculating the area density of the wetted area created visually by the wet extraction cleaner. This test method does not quantify drying time but provides an indication of comparative drying time for differentiating wet extraction cleaners.

1.3 This test method applies only to the cleaning of virgin, unsoiled, untreated carpet.

1.4 This test method is applicable to types of upright, canister, and combination wet extraction cleaners and their recommended detergent cleaning formulas intended for cleaning carpets as a primary or secondary function. This test method excludes pre-spray systems or pre-spray treatments.

1.5 This test method is not applicable to upholstery cleaning or bare floor cleaning.

1.6 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE
Standard Type: Main
Document No: ASTM F3733/F3733M : 24
Document Year: 2024
Pages: 5
  • Section Volume:
  • 15.11 Volume 15.11 Consumer Products; Vacuum Cleaners

Life Cycle

Currently Viewing

ACTIVE
ASTM F3733/F3733M : 24
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +