ASTM F1803 : 06

Standard Specification for Poly (Vinyl Chloride)(PVC) Closed Profile Gravity Pipe and Fittings Based on Controlled Inside Diameter (Withdrawn 2015)

Standard Details

1.1 This specification covers requirements for poly(vinyl chloride) (PVC) closed profile sewer pipe and fittings with integral bell and elastomeric seal joints or plain end pipe with couplings in sizes (18 to 60 in.) based on a controlled inside diameter.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

The following safety hazard caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

Pipe and fittings produced to this specification should be installed in accordance with Practice D 2321.

General Information

Status : Historical

Standard Type: Main

Document No: ASTM F1803 : 06

Document Year: 2006

Pages: 5

Section Volume:
08.04 Volume 08.04: Plastic Piping Systems (I): D1598 – F2735

ICS:
23.040.20 Plastics pipes

Preview Document

Life Cycle

Historical

ASTM F1803 : 15

ACTIVE

ASTM F1803 : 15(2019)

Currently Viewing

Historical

ASTM F1803 : 06

Historical

ASTM F1803 : 04

Historical

ASTM F1803 : 97

ASTM F1803 : 06

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form