logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM D3159 : 10

Standard Specification for Modified ETFE-Fluoropolymer Molding and Extrusion Materials

Standard Details

1.1 This specification covers melt processible molding and extrusion materials of modified ETFE-fluoropolymer. The ETFE resin is a copolymer of ethylene containing approximately 75 mass % of tetrafluoroethylene.

1.2 The values stated in SI units as detailed in are to be regarded as standard. The values given in parentheses are for information only.

Note 1—Although this specification and ISO 12086-1 (1994) and ISO 12086-2 (1994) differ in approach or detail, data obtained using either are technically equivalent.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 Recycled material is not appropriate for this specification because performance requirements cannot be met with recycled material. Therefore, this specification is for virgin material only.

General Information

Status : Historical
Standard Type: Main
Document No: ASTM D3159 : 10
Document Year: 2010
Pages: 5
  • Section Volume:
  • 08.01 Volume 08.01 Plastics (I): C1147-D3159

Life Cycle

Historical

Currently Viewing

Historical
ASTM D3159 : 10

Historical

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +