Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
1.1 This specification establishes the requirements for brass plate, sheet, strip, and rolled bar of the following alloys:2
Copper Alloy | Previous | Nominal Composition | |
Copper, % | Zinc, % | ||
|
|
|
|
C21000 | Gilding, 95 % | 95 | 5 |
C22000 | Commerical Bronze, 90 % | 90 | 10 |
C22600 | Jewerly Bronze, 871/2 % | 87.5 | 12.5 |
C23000 | Red Brass, 85 % | 85 | 15 |
C24000 | Low Brass, 80 % | 80 | 20 |
C26000 | Cartridge Brass, 70 % | 70 | 30 |
C26800 | Yellow Brass, 66 % | 66 | 34 |
C27200 | … | 63 | 37 |
C28000 | Muntz Metal, 60 % | 60 | 40 |
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.