logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM D7670 : 10(2021)

Standard Practice for Processing In-service Fluid Samples for Particulate Contamination Analysis Using Membrane Filters

Standard Details

1.1 This practice covers the processing of in-service fluids in preparation for particulate contamination analysis using membrane filters and is limited only by the liquid-to-membrane filter compatibility.

1.2 The practice covers the procedure for filtering a measured volume of liquid through a membrane filter. When this practice is used, the particulate matter will be randomly distributed on the filter surface for subsequent contamination analysis methods.

1.3 The practice describes procedures to allow handling particles in the size range between 2 µm and 1000 μm with minimum losses during handling.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE
Standard Type: Main
Document No: ASTM D7670 : 10(2021)
Document Year: 2010
Pages: 3
  • Section Volume:
  • 05.04 Volume 05.04 Petroleum Products, Liquid Fuels, and Lubricants (IV): D6973-D7755
  • ICS:
  • 23.100.60 Filters, seals and contamination of fluids

Life Cycle

Currently Viewing

ACTIVE
ASTM D7670 : 10(2021)

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +