logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM A833 : 08a(2014)

Standard Practice for Indentation Hardness of Metallic Materials by Comparison Hardness Testers

Standard Details

1.1 This practice covers the determination of indentation hardness of metallic materials using comparison hardness testers.

1.2 This practice applies only to those comparison hardness testers, normally portable, that use comparative test bars that have been standardized according to Test Method E10 as a basis for comparison.

1.3 Calibration of comparative test bars (rods), used for comparison to determine hardness numbers, is also covered by this practice.

1.4 The impression force used during comparison hardness testing is normally an impact load applied by striking a hammer on the appropriate areas as outlined in the manufacturer's instructions.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

General Information

Status : Historical
Standard Type: Main
Document No: ASTM A833 : 08a(2014)
Document Year: 2008
Pages: 3
Edition: a
  • Section Volume:
  • 01.05 Volume 01.05 Steel--Bars, Forgings, Bearing, Chain, Tool

Life Cycle

Historical

Currently Viewing

Historical
ASTM A833 : 08a(2014)

Historical
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +