ASTM F3334 : 19

1.1 This practice establishes requirements and considerations for the numerical simulation of metallic orthopaedic total knee tibial components using Finite Element Analysis (FEA) techniques for the estimation of stresses and strains. This practice is only applicable to stresses below the yield strength, as provided in the material certification.

1.2 Purpose—This practice establishes requirements and considerations for the development of finite element models to be used in the evaluation of metallic orthopaedic total knee tibial component designs for the purpose of prediction of the static implant stresses and strains. This procedure can be used for worst-case assessment within a series of different implant sizes of the same implant design to reduce the physical test burden. Recommended procedures for performing model checks and verification are provided as an aid to determine if the analysis follows recommended guidelines. Finally, the recommended content of an engineering report covering the mechanical simulation is presented.

1.3 Limits—This practice is limited in discussion to the static structural analysis of metallic orthopaedic total knee tibial components (which excludes the prediction of fatigue strength).

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International StandardDetails, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.