logo

Standards Manage Your Business

We Manage Your Standards

ASTM

ASTM E2024/E2024M : 11

Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector

Standard Details

1.1 This practice covers procedures for detecting the sources of gas leaking at the rate of 1 × 105 Pa m3/s (1 × 104 standard cm3/s) or greater. The tests may be conducted on any object that can be pressurized with a tracer gas that is detectable by a thermal conductivity detector. The test sensitivity will vary widely depending on the tracer gas used.

1.2 UnitsThe values stated in either SI or std-cc/sec units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

General Information

Status : Historical
Standard Type: Main
Document No: ASTM E2024/E2024M : 11
Document Year: 2011
Pages: 3
  • Section Volume:
  • 03.03 Volume 03.03 Nondestructive Testing (E94 – E2373)
  • ICS:
  • 19.100 Non-destructive testing

Life Cycle

Currently Viewing

Historical
ASTM E2024/E2024M : 11
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +