ASTM D6609/D6609M : 24

1.1 This guide covers general principles for obtaining a gross sample of coal by taking increments from part of a stream of coal rather than from the entire stream to be sampled. The usefulness of results from this guide will vary greatly depending on such factors as top size of the coal, size consistency of the coal, variability of the coal, and such logistical factors as the flow rate of the coal in process and physical accessibility of the sampling station.

1.2 This guide should be used only when it is not possible to use a method of sampling that produces a probability sample.

1.3 Sample preparation procedures involving crushing are contained in Practice D2013.

1.4 The values stated in either SI units or non-SI units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory requirements prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.