SAE 2009-01-1973 : 2009

Single Cylinder Diesel Engine Startup Experiments with Fast Cycle Resolved In-cylinder and Exhaust Sampling

Standard Details

Single cylinder diesel engine cycle resolved startup experiments were performed at two different Compression Ratios. At CR18 (CR = 18) conventional engine starting resulted in a broad range of acceptable startup equivalence ratios (φ). However, reducing the CR to 16 resulted in problematic engine starting regardless of fuel level. In an effect to produce robust engine starting at lower CRs the engine was motored first. This allowed for strong starting performance coupled with high load fueling levels. For both CRs, IMEP g and exhaust CO 2 % increased as fueling level increased. However, while in-cylinder CO 2 % exceeded exhaust CO2% for moderate φ, this trend was reversed as fueling was reduced. Exhaust CO% was minimal except for stoichiometric fueling at CR18. Peak NOx production occurred at CR18 and φ = 0.55. Exhaust UHCs were maximized for higher fueling cases but dropped quickly after start. Similarly, ignition delay increased with φ but decreased during warm-up. As a result, burn duration was shortest with higher fueling and tended to decrease a few seconds after start. In-cylinder UHC started high (5000 - 15000 ppm) but decreased steadily during warm-up and dropped by one or two orders of magnitude during the exhaust phase. Finally, soot emissions were relatively independent of CR and increased with fueling level.

Cross Reference:

General Information

Status : ACTIVE

Standard Type: Main

Document No: SAE 2009-01-1973 : 2009

Document Year: 2009

Preview Document

Life Cycle

Currently Viewing

ACTIVE

SAE 2009-01-1973 : 2009

SAE 2009-01-1973 : 2009

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form