logo

Standards Manage Your Business

We Manage Your Standards

IEC

IEC 62047-47:2024

Semiconductor devices - Micro-electromechanical devices - Part 47: Silicon based MEMS fabrication technology - Measurement method of bending strength of microstructures

Standard Details

IEC 62047-47:2024 specifies the requirements and testing method to measure the bending strength of microstructures which are fabricated by micromachining technology used in silicon-based micro-electromechanical system (MEMS).
This document is applicable to the in-situ bending strength measurement of microstructures manufactured by microelectronic technology process and other micromachining technology.
With the devices scaling, the bending strength degradation, induced by defects and contaminations, becomes more severe. This document specifies an in-situ testing method of the bending strength based on MEMS technique. This document does not need intricate instruments (such as scanning probe microscopy and nanoindenter) and special test specimens.
Since in-situ on-chip tester in this document and device are fabricated with the same process on the same wafer, this document can give some practical reference for the design part.

General Information

Status : ACTIVE
Standard Type: Main
Document No: IEC 62047-47:2024
Document Year: 2024
Pages: 16
Edition: 1.0

Life Cycle

Currently Viewing

ACTIVE
IEC 62047-47:2024
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +