Resistance welding — Testing of welds — Peel and chisel testing of resistance spot and projection welds
This document specifies the procedures and recommended tooling to be used for peel and chisel testing of resistance spot and embossed projection welds. This document applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm.
The aim of these tests is to determine:
— weld size and failure mode when welds are destructively tested;
— verification of welds by non-destructive chisel tests.
NOTE The preferred method of peel testing seam welds (mechanized peel testing) is covered in ISO 14270.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.