ISO 10350-1:2007

Plastics — Acquisition and presentation of comparable single-point data — Part 1: Moulding materials

Standard Details

ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets.

ISO 10350-1:2007 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

General Information

Status : WITHDRAWN

Standard Type: Main

Document No: ISO 10350-1:2007

Document Year: 2007

Pages: 10

Edition: 2

Section Volume:
ISO/TC 61/SC 2. Mechanical properties

ICS:
83.080.20 Thermoplastic materials

Preview Document

Life Cycle

WITHDRAWN

ISO 10350-1:2017

Published

ISO 10350-1:2025

Currently Viewing

WITHDRAWN

ISO 10350-1:2007

WITHDRAWN

ISO 10350-1:1998

ISO 10350-1:2007

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form