Standards Manage Your Business
We Manage Your Standards
Standards Manage Your Business
We Manage Your Standards
Paper and board — Determination of bending resistance — Part 1: Constant rate of deflection
ISO 2493-1:2010 applies to the measurement of the bending resistance within the range 20 mN to 10 000 mN. It is not applicable to corrugated board but can be applicable to the components of such board.
The bending angle is 15° and the bending length is 50 mm.
For samples having a bending resistance that is too low to measure with a bending length of 50 mm, a shorter bending length, i.e. 10 mm, can be used.
For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.
