logo

Standards Manage Your Business

We Manage Your Standards

CSA

CSA ISO/IEC 29341-24-10:19 (R2024)

Information technology — UPnP Device Architecture — Part 24-10: Internet gateway device control protocol — Level 2 — Wide area network internet protocol — Connection service (Adopted ISO/IEC 29341-24-10:2017, first edition, 2017-09)

Standard Details

CSA Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the SCC Mirror Committee (SMC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T). For brevity, this Standard will be referred to as “CSA ISO/IEC 29341-24-10” throughout. At the time of publication, ISO/IEC 29341-24-10:2017 is available from ISO and IEC in English only. CSA Group will publish the French version when it becomes available from ISO and IEC. The International Standard was reviewed by the CSA TCIT under the jurisdiction of the CSA Strategic Steering Committee on Information and Communications Technology and deemed acceptable for use in Canada. From time to time, ISO/IEC may publish addenda, corrigenda, etc. The TCIT will review these documents for approval and publication. For a listing, refer to the Current Standards Activities page at standardsactivities.csagroup.org. This Standard has been formally approved, without modification, by the Technical Committee and has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group. Scope This document specifies the characteristics of the UPnP networked service named WANIPConnection, version 2. This service definition is compliant with UPnP Device Architecture 1.0 [1] . It is one component of the Device Control Protocol for the UPnP Internet Gateway Device (see [3]). This service enables a UPnP control point to: - configure and control an IP connection between a LAN client on one side of an Internet gateway (see [3]) and a WAN host on the other side; - manage any physical WAN interface—such as DSL or cable—that supports an IP connection. This service is a required in a WANConnectionDevice (see [5]) when the device supports an IP connection.

General Information

Status : ACTIVE
Standard Type: Main
Document No: CSA ISO/IEC 29341-24-10:19 (R2024)
Document Year: 2019
Pages: 90
Adopted: Yes

Life Cycle

Currently Viewing

ACTIVE
CSA ISO/IEC 29341-24-10:19 (R2024)
Knowledge Corner

Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!

© Copyright 2024 BSB Edge Private Limited.

Enquire now +