ISO 16183:2002

Heavy duty engines — Measurement of gaseous emissions from raw exhaust gas and of particulate emissions using partial flow dilution systems under transient test conditions

Standard Details

ISO 16183 specifies methods for the measurement and evaluation of gaseous and particulate exhaust emissions from heavy-duty engines under transient conditions on a test bed. The procedures it defines can be applied to any transient test cycle that does not require extreme system response times; it can therefore be used as an option to the regulated measurement equipment (usually CVS-type systems) of certification test cycles (e.g. ETC and FTP), with the approval of the certification agency.

ISO 16183 is applicable to heavy-duty engines for commercial vehicles primarily designed for road use, but can also be applied to passenger car engines and to engines used for non-road applications. The test equipment specified can also be applied to steady-state test cycles, however, if so, the calculation procedures will need to be replaced by those applicable to the particular test cycle.

General Information

Status : Published

Standard Type: Main

Document No: ISO 16183:2002

Document Year: 2002

Pages: 64

Edition: 1

Section Volume:
ISO/TC 22/SC 34. Propulsion, powertrain and powertrain fluids

ICS:
13.040.50 Transport exhaust emissions
43.060.20 Pressure charging and air/exhaust gas ducting systems

Preview Document

Life Cycle

Currently Viewing

Published

ISO 16183:2002

ISO 16183:2002

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form