Collets for tool holders with taper ratio 1:10 — Collets, holders, nuts
ISO 10897:2016 specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.
Form A applies where a clamping range of H10 is sufficient.
Form B can be used for any application without lateral cutting load.
Annex A specifies the values for AT3 tolerance and AT4 tolerance.
Currently Viewing
Expand Your Knowledge and Unlock Your Learning Potential - Your One-Stop Source for Information!
© Copyright 2024 BSB Edge Private Limited.